5 Tools
186
Tools
5
z
Direct Authentication
User ID and password entered by a user are used for LDAP authentication.
z
Authentication of User Attributes
The user ID entered is used as an attribute specified in [Attribute of Typed User Name] to
perform a search on the LDAP server. [Attribute of Login User Name] of a user found through
the search is used as the user ID of a job and the owner of a job flow sheet and a folder.
îš„Attribute of Typed User Name
When [Authentication of User Attributes] is used for LDAP authentication, set the attribute of
the user ID entered. Up to 32 characters are allowed.
Set the attribute of the UserAttribute information registered on the LDAP server that
corresponds to the value to be entered as the user name from the control panel. For example,
when you want a user to enter the mail address, set "mail."
îš„Attribute of Login User Name
Enter an attribute to be used for LDAP authentication using UserAttribute information
registered on the LDAP server. Up to 32 characters are allowed.
îš„Use Added Text String
Select whether or not to automatically add text strings in [Text String Added to User Name]
when you enter the authentication information from the control panel.
îš„Text String Added to User Name
Enter text strings for [Text String Added to User Name] when you use additional text strings.
Up to 64 characters are allowed.
When [Use Added Text String] is set to [Enabled], enter the corresponding fixed text string.
For Example:
When "mail" is set for [Attribute of Typed User Name] and the information registered for the
target user is "mail@myhost.example.com," you will need to enter
"mail@myhost.example.com".
However, if [Use Added Text String] is set to [Enabled] and "@myhost.example.com" is
specified for [Text String Added to User Name], you will only need to enter "mail" from the
control panel because the machine adds "@myhost.example.com" to the end of the string.
îš„Attribute of Smart Card (ApeosPort Series Models Only)
When a smart card is used for LDAP authentication, set the attribute of the card ID to perform
a search on the LDAP server to authenticate the user who has the card. Up to 32 characters
are allowed.
Note • This item is displayed when [Smart Card Link Mode] under [Tools] > [Authentication/Security
Settings] > [Authentication] > [User Details Setup] is set to [No Passcode Required].
îš„Network User ID Attribute (ApeosPort Series Models Only)
When a smart card is used for LDAP authentication, set the attribute of the user name to be
used for a smart card ID search. The user name is given to the remote service as the
authentication information. Up to 32 characters are allowed.
Note • This item is displayed when [Smart Card Link Mode] under [Tools] > [Authentication/Security
Settings] > [Authentication] > [User Details Setup] is set to [No Passcode Required].
îš„Login Credentials to Search Entries
Select which users are allowed to search the Address Book.
You can select from [Remotely Authenticated User] or [System].
îš„Login Name
Set a user name for the Address Book search and access to the directory server using
[Authentication of User Attributes] method for LDAP authentication. However, set this item
only when authentication is required for the directory service. Up to 255 characters are
allowed.
îš„Password
Set a login password for the user specified in [Login Name]. Up to 32 characters are allowed.
îš„Search Directory Root
Enter a search root character string with up to 255 characters.
To Next Page
Loading...
Need help?
General
