Adjust Image Transfer
667
Appendix
16
Adjust Image Transfer
This section describes how to adjust the transfer output value.
You can specify the transfer output value. This is useful when the toner image does not
transfer to the paper properly.
Adjusting the Transfer Output Value
You can specify the image transfer output value for each paper type.
1 Press the <Log In/Out> button and enter the
System Administration mode.
For how to enter the System Administration mode, refer to
"System Settings Procedure" (P.140).
2 Select [Tools] on the Services Home screen.
3 Select [System Settings] > [Common Service
Settings] > [Maintenance].
4 Select [Adjust Image Transfer].
5 Select [Paper Type].
To Next Page
Loading...
