16 Appendix
700
Appendix
16
Basic Settings
Parameter Item No. Value
Document size 101 Sets the document size created by a computer.
[0] : A0
[1] : A1
[2] : A2
[3] : A3
[4] : A4
[5] : A5
[10] : B0
[11] : B1
[12] : B2
[13] : B3
[14] : B4
[15] : B5
[99] (Default) : Auto
[100] : Paper
When [Auto] is selected, the settings of the Scaling mode, the Area
Determination mode, and the Paper Margin settings of Print Control become
enabled.
Note • If the document size other than [Auto] is selected, the settings under [Auto
layout] become [ON].
• Depending on the combination of [Document size] and [Paper size], the
document is printed at a scale of 100%.
Paper size 102 Sets the default paper size. Only available when [Paper tray] is set to [Auto] or
[Tray 5]. Only cut sheet can be set.
[3] : A3
[4] (Default) : A4
[5] : A5
[14] : B4
[15] : B5
[99] : Auto
[101] (Default) : A Size
Important • When Trays 1 to 4, Tray 6 is selected, [Paper size] cannot be set. The paper
size loaded in the specified tray is displayed.
Note • If [A Size] or [Auto] is selected, the settings become as follows:
- When [Document size] is set to other than [Auto], [Paper size] is set to
[A3].
- When Trays 1 to 4, Tray 6 is selected, the paper size is determined by the
size of paper loaded in the tray, and thus [Paper size] cannot be set.
- Depending on the combination of [Document size] and [Paper size], [?]
may be displayed for the magnification. In this case, the document is
printed at a scale of 100%.
To Next Page
Loading...
