General Information
40
3
Data Remaining
There is remaining print data in the machine's memory. If the Ready LED ( ) is blinking for a long time
and nothing has printed, press to print the remaining data in the memory.
The Ready LED ( ) will blink in 0.5 second intervals.
Toner Low
The toner cartridge will need to be replaced soon. Buy a new toner cartridge and have it ready for when
Replace Toner is indicated.
Both the Ready () and Error () LEDs will turn on together, then the Error LED () will turn off
after 0.5 seconds and the
Ready LED () will turn off after 1 second, they will then both be off
for a further 1 second. This procedure is repeated until the error is corrected.
If the printout is faint, hold the drum unit and toner cartridge assembly level with both hands and gently
shake it from side to side several times to spread the toner evenly inside the cartridge.
Replace Toner (Continue mode)
The machine continues printing until the LED indicates Toner Ended.
Both the Ready () and Error () LEDs will turn on together, then the Error LED () will turn off
after 0.5 seconds and the
Ready LED () will turn off after 1 second, they will then both be off
for a further 1 second. This procedure is repeated until the error is corrected.
For details about Continue mode, see Toner Setting on page 50.
Replace Toner (Stop mode)
Replace the toner cartridge with a new one.
The Error LED ( ) will blink once in 1.5 seconds intervals.
For details about Stop mode, see Toner Setting on page 50.
(See the instructions printed on the box of the new toner cartridge.)
No Toner
Remove the drum unit and toner cartridge assembly, remove the toner cartridge from the drum unit, and
re-install the toner cartridge back into the drum unit again. Re-install the drum unit and toner cartridge
assembly back in the machine. If the problem continues, replace the toner cartridge.
The Error LED ( ) will blink once in 1.5 seconds intervals.
(See the instructions printed on the box of the new toner cartridge.)
Toner Ended
Replace the toner cartridge with a new one.
The Error LED ( ) will blink once at 1.5 seconds intervals.
(See the instructions printed on the box of the new toner cartridge.)
Cartridge Error
The drum unit and toner cartridge assembly is not installed correctly. Take the drum unit and toner
cartridge assembly out of the machine and put it back in. Use only a Fuji Xerox Original drum unit and
Fuji Xerox Original toner cartridge.
The Error LED ( ) will blink 4 times and turn off for 1 second.
LEDs Machine Status
To Next Page
Loading...
Need help?
General
