3
NOTES ON USING YOUR DPC-R1 CORRECTLY
●
Do not turn off the personal computer power, while the “READY/ACCESS lamp” is on
or blink.
The xD-Picture Card, SmartMedia Card and internal data will be destroyed.
●
Do not drop or otherwise apply strong shock or vibration to the DPC-R1.
Strong shock or vibration will damage the DPC-R1 or cause trouble.
●
Do not store, or use, the DPC-R1 with heavy objects atop it.
Heavy objects will damage the DPC-R1, or cause trouble.
●
Do not touch the pins of the USB connector.
Touching the pins may damage the DPC-R1 and the personal computer.
●
When disconnecting the USB interface cable, pull out the connector while pressing
the end with your finger.
Forcefully pulling out the cable itself will damage the DPC-R1 and the cable.
●
Do not use cable other than the cable supplied.
The use of other cable will cause erroneous operation.
●
When inserting the xD-Picture Card or SmartMedia Card, pay careful attention to the
direction of the card. Inserting the xD-Picture Card or SmartMedia Card in reverse
may cause trouble.
●
The DPC-R1 does not support 2MB SmartMedia. Note also that when a 2MB
SmartMedia and an xD-Picture Card are loaded at the same time, the xD-Picture
Card cannot be accessed after the SmartMedia has been accessed. Open the cover
and remove the 2MB SmartMedia.
To Next Page
Loading...