I
For
Your
Safety
IMPORTANT
SAFETY
INSTRUCTIONS
Ā·
Read
Instructions:
All
the
safety
and
operating instructions
should
be
read
before
the
appliance
is
operated.
Ā·
Retain
Instructions:
The
safety and
operating instructions should
be
retained for future reference.
Ā·
Heed
Warnings:
All
warnings on the
appliance and
in
the operating
instructions should
be
adhered
to.
ā¢
Follow
Instructions:
All
operating
and
use
instructions should
be
followed.
Power
Sources:
This
video product
should be operated only from the
type
of
power
source
indicated on
the marking label. If you
are
not
sure
of the type
of
power supply to your
home, consult your appliance dealer
or local power company.
For
video
products intended to operate from
battery power, or other
sources,
refer
to the operating instructions
Grounding
or
Polarization:
This
video product
is
equipped with a
polarized alternating-current line
plug
(a
plug having one blade
wider than the other).
This
plug
will fit into the power outlet only
one
way.
This
is
a safety feature. If
you
are
unable to insert the plug
fully into the outlet, try reversing
the plug. If the plug should still
fail
to fit, contact your electrician to
replace your obsolete outlet.
Do
not defeat the safety purpose
of
the
polarized plug
00
II
Alternate
Warnings:
This
video
product
is
equipped with a three-
wire grounding-type plug, a plug
having athird (grounding) pin.
This
plug will only fit into a grounding-
type power outlet.
This
is
asafety
feature. Ifyou
are
unable to insert
the plug into the outlet, contact your
electrician to
replace
your obsolete
outlet.
Do
not defeat the safety
purpose
of
the grounding type plug.
Overloading:
Do
not overload
wall
outlets
and
extension
cords
as
this
can
result
in
a
risk
of
fire
or
electric
shock,
Ventilation:
Slots
and
openings
in
the cabinet
are
provided for
ventilation, to ensure reliable
operation
of
the video product
and to protect it from overheating,
and these openings must not
be
blocked or covered.
The
openings
should never
be
blocked by placing
the video product
on
a bed,
sofa,
rug, or other similar
surface.
This
video product should not
be
placed
in
a built-in installation
such
as
a bookcase or
rack
unless
proper ventilation
is
provided
or
the
manufacturer's instructions
have
been
adhered
to.
This
video product
should never
be
placed
near
or
over
a radiator or
heat
register.
Attachments:
Do
not
use
attachments not recommended
by
the video product manufacturer
as
they may
cause
hazards.
Water
and
Moisture:
Do
not
use
this
video product near
water-for
example, near a bath tub,
wash
bowl, kitchen
sink,
or laundry
tub,
in
a wet basement, or near a
swimming pool, and the
like.
Power-Cord
Protection:
Power-supply
cords
should
be
routed
so
that
they
are
not
likely
to
be
walked
on
or
pinched
by
items
placed
upon
or
against
them,
paying
particular
attention
to
cords
at
plugs,
convenience
receptacles,
and
the
point
where
they
exit
from
the
appliance.
Accessories:
Do
not place this video
product
on
an
unstable cart, stand,
tripod, bracket, or table. The video
product
may
fall,
causing serious
injury to achild or adult, and serious
damage to the appliance.
Use
only
with a cart, stand, tripod, bracket, or
table recommended by
he
manufacturer, or sold with the video
product. Any mounting
of
the
appliance should follow the
manufacturer's instructions,
and
should
use
a mounting accessory
recommended by the manufacturer.
An
appliance and
cart combination
should
be
moved
with
care.
Quick
stops,
excessive
force,
and
uneven surfaces
may
cause
the appliance and cart
combination to overturn.
Outdoor
Antenna
Grounding:
If
an
outside
antenna
or
cable
system
is
connected
to
the
video
product,
be
sure
the
antenna
or
cable
system
is
grounded
so
as
to
provide
some
protection
against
voltage
surges
and
bUilt-up
static
charges.
Section
810
of
the
National
Electrical
Code,
ANSI/NFPA
No.
70,
provides
information with
respectto
proper
grounding of
the
mast
and
supporting
structure,
grounding of
the
lead-in
wire
to
an
antenna
discharge
unit,
size
of
grounding
conductors,
location
of
antenna
discharge
unit,
connection
to
grounding
electrodes,
and
requirements
for
the
grounding
electrode.
EXAMPLE
OF
ANTENNA
GROUNDING
AS
PER
NATIONAL
ELECTRICAL
CODE
Ground Antenna
Lead
Clamp~---:
-in
Wire
Electric
~"\J
.Ā·
~
Antenna
Service\1
I.
I Discharge
Equipment
",
_ Unit
(NEC
1\
J
SECTION
Ground
..."
~_\--
810-20)
C1omps-J...--;-
~
..
Grounding
Power
Service
Grounding Conductors
Electrode
System
(NEC
(NEC
SECTION
ART25o.
PARTH)
8/0-21)
Power
Lines:
An
outside antenna
system should not
be
located
in
the
vicinity
of
overhead power lines or
other electric light
or
power circuits,
To Next Page
Loading...
