To Next PageTo Next Page
Need help?Do you have a question about the Fujikura 41S and is the answer not in the manual?
General| Model | 41S |
|---|---|
| Alignment Method | Core Alignment |
| Return Loss | ≥60 dB |
| Automatic Heating Start | Yes |
| Operating Temperature Range | -10 °C to +50 °C |
| Applicable Fibers | SM, MM, DS, NZDS |
| Cladding Diameter | 80 μm - 150 μm |
| Fiber Cleave Length | 8-16 mm |
| Splice Loss | 0.02 dB (SMF), 0.01 dB (MMF) |
| Applicable Protection Sleeve Length | 40 mm, 60 mm |
| Data Output | USB |
| Screen | 4.7 inch color LCD monitor |
| Power Supply | AC 100-240V, 50/60Hz, DC 12V |
| Fiber Types | SM (ITU-T G.652&G.657), MM (ITU-T G.651), DS (ITU-T G.653), NZDS (ITU-T G.655) |
Explains warning symbols (WARNING!, CAUTION!), and action symbols (Pay attention, Must not do, Must do).
Lists critical safety warnings related to power, disassembly, environment, and handling of components.
Details cautions related to power source, cord usage, and electrical connections to prevent hazards.
Details AC adapter and battery operation, including precautions for AC generators.
Explains how to charge the battery and interpret battery status indicators.
Describes how to view the remaining battery capacity on the screen.
Provides step-by-step instructions for removing and installing the battery pack.
Explains how to choose the correct splice mode for different fiber types.
Details the steps to select and change the splice mode via the touch panel.
Guides on choosing the appropriate heater mode for specific protection sleeves.
Outlines the process for selecting and changing heater modes on the device.
Covers cleaning optical fiber and placing the protection sleeve.
Details the steps for cleaving the fiber using the CT08 or CT50 cleaver.
Explains how to use fiber holders for proper fiber placement during cleaving.
Describes how to place the prepared fiber into the splicer using sheath clamps.
Details the process of loading fiber using a fiber holder.
Explains the importance and procedure for performing arc calibration.
Interprets the "Good" and "Not Adequate" messages from arc calibration.
Guides through the standard splicing process, including fiber alignment and cleave checks.
Discusses splice loss estimation, error messages, and re-arcing for improvement.
Lists common causes for splice loss increase and their remedies.
Details the steps for inserting and heating the protection sleeve.
Guides on cleaning the V-grooves and fiber clamp chips to ensure splice quality.
Explains how to clean the fiber cleaver's blade and clamp pads.
Details the procedure for cleaning the objective lens to maintain accurate observation.
Covers repositioning the cleaver blade using different methods.
Explains how to adjust the blade height on the CT50 and CT08 cleavers.
Information on replacing cleaver blades and clamp arms.
Outlines the structure and how to change splice modes.
Details parameters for controlling arc discharge, alignment, and loss estimation.
