To Next PageTo Next Page
Need help?Do you have a question about the Fujikura 36S and is the answer not in the manual?
General| Model | 36S |
|---|---|
| Splicing Method | Core Alignment |
| Return Loss | ≥60dB |
| Data Output | USB |
| Cladding Diameter | 80μm - 150μm |
| Coating Diameter | 100-1000 µm |
| Fiber Cleave Length | 8-16 mm |
| Arc Calibration Method | Automatic |
| Applicable Protection Sleeve | 40 mm, 60 mm |
| Splice & Heat Memory | 1000 sets |
| Monitor | 5 inch color LCD monitor |
| Power Supply | AC adapter or rechargeable battery |
| Operating Condition | -10°C to 50°C, 0-95% RH (non-condensing) |
| Storage Condition | 0-95% RH (non-condensing) |
| Dimensions | 150H mm |
| Weight | 2.5 kg (including battery) |
| Applicable Fibers | SM, MM, DS, NZDS |
Guidance on following safety protocols and understanding the manual.
Explanation of warning symbols like CAUTION! and WARNING! and their meanings.
Precautions for using AC adapter, power cord, and avoiding electrical hazards.
Procedures for using AC adapter and internal battery.
Steps for cleaning, stripping, and cleaving optical fibers.
Inserting fibers into the splicer and performing arc calibration.
Detailed steps for splicing and analyzing splice loss.
Routine cleaning of V-grooves, clamp chips, and fiber cleaver.
Information on common error messages and their solutions.
How to select, create, delete, and edit splice modes.
Procedures for arc calibration, dust checks, and diagnostic tests.
Comprehensive list of error messages, reasons, and solutions.
