To Next PageTo Next PageWhat to do if fiber protection sleeve adhered to heating plate after shrink in Fujikura Welding System?
If a fiber protection sleeve adheres to the heating plate after shrinking in your Fujikura Welding System, use a cotton swab or a similar soft-tipped object to gently push and remove the protection sleeve.
General| Model | 90S |
|---|---|
| Category | Welding System |
| Splice Loss (SM) | 0.02dB |
| Splice Loss (MM) | 0.01dB |
| Splice Loss (DS) | 0.04dB |
| Splice Loss (NZDS) | 0.04dB |
| Data Output | USB |
| Fiber Alignment | Core Alignment |
| Display | 5-inch color LCD |
| Applicable Fibers | SM, MM, DS, NZDS |
| Fiber Count | Single |
| Cladding Diameter | 125 µm |
| Fiber Cleave Length | 8-16 mm |
| Splicing Mode | Automatic |
| Heating Mode | Automatic |
| Return Loss | ≥ 60 dB |
Important warnings and cautions for safe operation and handling.
Steps for splicing preparation, power connection, and battery use.
Understanding the READY screen and selecting operation/splice/heater modes.
Calibration, splicing steps, loss estimation, and storing results.
Setup, status check, and turning wireless communication on/off.
Handling error messages, power issues, and operational problems.
