En-4
PREPARATION
CAUTION!
● Take care to prevent infants from acciden-
tally swallowing batteries.
● When not using the Remote Controller for
an extended period, remove the batteries
to avoid possible leakage and damage to
the unit.
● If leaking battery fluid comes in contact
with your skin, eyes, or mouth, imme-
diately wash with copious amounts of
water, and consult your physician.
● Dead batteries should be removed imme-
diately and disposed of properly, either in
a battery collection receptacle or to the
appropriate authority.
● Do not attempt to recharge dry batteries.
Never mix new and used batteries, or
batteries of different types.
Batteries should last about one year
under normal use. If the Remote Con-
troller’s operating range becomes appre-
ciably reduced, replace the batteries and
press the RESET button with the tip of a
ballpoint pen or other small object.
Load Batteries (R03/LR03
××
××
× 2)
1
Press and slide the battery compartment lid on the re-
verse side to open it.
Slide in the direction of the arrow while pressing the mark.
2
Insert batteries.
Be sure to align the battery polarities ( ) correctly.
3
Close the battery compartment lid.
Set the Current time
1
Press the CLOCK ADJUST button.
Use the tip of a ball-point pen or other small object to press the button.
2
Use the TIMER SET ( / ) buttons to adjust the
clock to the current time.
button: Press to advance the time.
button: Press to reverse the time.
(Each time the buttons are pressed, the time will be advanced/reversed in
one-minute increments; hold the buttons depressed to change the time
quickly in ten-minute increments.)
3
Press the CLOCK ADJUST button again.
This completes the time setting and starts the clock.
To Use the Remote Controller
● The Remote Controller must be pointed at signal receiver to operate correctly.
● Operating Range: About 7 meters.
● When a signal is properly received by the air conditioner, a beeping sound will
be heard.
● If no beep is heard, press the Remote Controller button again.
Remote Controller Holder
3 To remove the Remote
Controller (when use at
hand).
1 Mount the Holder. 2 Set the Remote Controller.
Screws
Insert
Press in
Slide up
Pull out
9374379262-03_OM_en.p65 2/4/10, 3:06 PM4
To Next Page
Loading...
Need help?
General
