To Next PageTo Next Page
Need help?Do you have a question about the Fujitsu AGYV09LAC and is the answer not in the manual?
General| Cooling Capacity | 2.5 kW |
|---|---|
| Heating Capacity | 3.2 kW |
| Weight (Indoor Unit) | 9 kg |
| Type | Split System |
| Power Supply | 50 Hz |
Detailed fault codes and diagnostics for Classic ASY9-12LSACW.
Detailed fault codes and diagnostics for Classic ASY9-12LSBCW.
Troubleshooting and error codes for Classic ASYA07-18LCC series.
Troubleshooting and error codes for Classic ASYA07-14LGC series.
Detailed fault codes for Classic ASYB09-24LDC series.
Fault codes for Gulvmodell AGYV09-14LAC series.
Fault codes for Nocria AWYZ14-18LBC series.
Continued fault codes for Nocria AWYZ14-18LBC series.
Further fault codes for Nocria AWYZ14-18LBC series.
Additional fault codes for Nocria AWYZ14-18LBC series.
Detailed troubleshooting procedures for Fujitsu inverter outdoor units.
A 10-point plan for checking inverter units.
Diagram for the 10-point check on ASY9-12LSACW models.
Diagram for 10-point check on ASY9-12LSB and ASYA9-12LCC.
Diagram for 10-point check on ASYA14-18LCC and ASYB09/12LDC.
Diagram for 10-point check on ASYA12-14LGC outdoor units.
Diagram for 10-point check on AGYV09-12-14LAC models.
Diagram for 10-point check on AWYZ14-18LBC models.
Diagram for 10-point check on AWYZ24LBC models.
Wiring diagram related to the 10-point inverter check.
Correct temperature sensor values for inverter analysis.
Analysis of the diode bridge component for fault diagnosis.
Continued analysis of the diode bridge for fault diagnosis.
Analysis of the Active Filter module for inverter fault diagnosis.
Further analysis of the Active Filter module.
Analysis of the IPM module for inverter fault diagnosis.
Analysis of compressor specifications and normal values.
Analysis of EEV (Electronic Expansion Valve) for inverter faults.
Procedure for pump down function on large models.
Procedure for pump down function on small models.
Continued pump down procedure for small models.
Continued pump down procedure for large models.
Electrical, compressor, fan motor, dimensions, weight, and noise specs.
Wiring diagram for ASY9LSACW/ASY12LSACW indoor and outdoor units.
Electrical, compressor, fan motor, dimensions, weight, and noise specs.
Wiring diagram for ASY9LSBCW/ASY12LSBCW indoor and outdoor units.
Electrical, compressor, fan motor, dimensions, weight, and noise specs.
Wiring diagram for ASYA07LCC/ASYA09LCC indoor and outdoor units.
Electrical, compressor, fan motor, dimensions, weight, and noise specs.
Wiring diagram for ASYA12LCC/AOYR12LCC indoor and outdoor units.
Electrical, compressor, fan motor, dimensions, weight, and noise specs.
Wiring diagram for ASYA14LGC/AOYR14LGC indoor and outdoor units.
Electrical, compressor, fan motor, dimensions, weight, and noise specs.
Wiring diagram for ASYB09LDC/AOYS09LDC indoor and outdoor units.
Electrical, compressor, fan motor, dimensions, weight, and noise specs.
Wiring diagram for ASYB18LDC/AOYS18LDC indoor and outdoor units.
Electrical, compressor, fan motor, dimensions, weight, and noise specs.
Wiring diagram for AWYZ14LBC/AOYZ14LBC indoor and outdoor units.
Electrical, compressor, fan motor, dimensions, weight, and noise specs.
Wiring diagram for AWYZ24LBC/AOYZ24LBT indoor and outdoor units.
Electrical, compressor, fan motor, dimensions, weight, and noise specs.
Wiring diagram for AGYV09LAC/AGYV12LAC/AGYV14LAC indoor and outdoor units.
Step-by-step guide for unit installation.
Diagram showing pipe entry method through a wooden wall.
Procedure for connecting manometer and performing vacuum test.
Table of water boiling points at different pressure levels for vacuuming.
Procedure for refilling R410A and R407C refrigerant with manometer.
Procedure for recovering refrigerant gas back into the system.
Procedure for pump down function on small models.
Procedure for pump down function on large models.
Steps for system evacuation and refrigerant refill.
Procedure for performing pressure tests using nitrogen.
