Fujitsu Airstage UTY-RSRY - Page 684

17) Set the setting number with the SET TEMP. “ ” or SET TEMP. “ ” button. Then press
the “ ” button.
Refrigerant circuit address
18) Setting results are displayed after data transmission.
GOODERROR
Refrigerant circuit address
Ex.) When indoor unit
address data "18" is
set up
● When refrigerant circuit address
data was normally set up on the
indoor unit.
● When refrigerant circuit address
data was not set up on the indoor
unit (-- is displayed.)
● Set up refrigerant circuit address
data again.
19) Press the “ ” button to return to the 2-wire remote controller address selection screen
of (2). If setting has been completed, press the FAN “ ” button to return to the Menu 2-F1
item selection screen.
NOTE:
● This item cannot be set from slave remote controllers.

COMPLETION OF ADDRESS SETTING MODE
20) Press and hold the FAN “ ” button for at least 2 seconds to return to the Menu 1 item
selection screen. Then, press and hold the SET TEMP. “ ” and FAN “ ” button for at least
2 seconds at the same time to return to the “Monitor Mode” screen.
- (07 - 37) -
FUNCTION SETTING FUNCTION SETTING