EasyManua.ls Logo

Fujitsu AJYA36LALH - Transmission Wiring and Address Settings; Transmission Wiring Rules; Automatic Address Setting Methods

Fujitsu AJYA36LALH
23 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
En-10
Transmission wiring speci cations6. 4. 1.
Follow the speci cations below for the transmission cable.
Use Size Cable type Remarks
Transmission cable 0.33mm
2
22AWG LEVEL 4 (NEMA)
non-polar 2core, twisted pair
solid core diameter 0.65mm
LONWORKS ®
compatible cable
Wiring rules6. 4. 2.
(1)Total length of transmission cable
Total transmission line length: MAX 3600m
EF+EG+GH+HJ+HK+KL < 3600m (Fig.2)
In the following cases , Signal Ampli er is required.
①
When the total length of the transmission line exceeded 500m.
AB+BC+BD > 500m (Fig.1)
②
When the total number of units* is over 64.
Transmission line length between each unit*
400m
(2)Length of transmission cable between 1 network segment (NS)
EF+EG+GH+HJ+HK
500m (Fig.2)
KL
400m (Fig.2)
Unit* means indoor unit, outdoor unit, Touch Panel Controller and System Controller,
Signal Ampli er, single split adaptor, Network Convertor etc..
1Fig.
Transmission line
Outdoor unit
Indoor unit
System
Controller
Touch
Panel
Controller
Terminal
resistor
When AB+BC+BD>500m
:Signal Ampli er is required.
A
B
C
D
2Fig.
Do not use loop wiring. NOTE)
This may lead to parts
damage and erroneous
operation.
Outdoor unit
Indoor unit
Signal Ampli er
System
Controller
Touch
Panel
Controller
Transmission line
Terminal resistor
Terminal resistor
NS 1
NS 2
F
H
L
G
K
J
E
Enabling/Disabling automatic address setting6. 4. 3.
You can enable/disable automatic address setting for the indoor unit and the signal
ampli er.
To enable automatic address setting for the indoor unit, connect the indoor unit to out-
door units under the same refrigerant system.(Fig.4)
Example: Disable Automatic Address setting
Refrigerant
system 1
Refrigerant
system 2
Refrigerant
system 3
Transmission line
Transmission line
Transmission line
Example: Enable Automatic Address setting
Refrigerant
system 1
Refrigerant
system 2
Refrigerant
system 3
Transmission line
Transmission line
Transmission line
9380545026-02_IM.indb 109380545026-02_IM.indb 10 19/08/2013 17:20:0119/08/2013 17:20:01

Related product manuals