Preparing your notebook for us e
Switching the notebook on for the first t ime
Switchingonforthefirsttime
We recommend that the notebook is supplied with power through
the mains adapter during this procedure .
When you switch your no tebook on for the first time, the supplied software
is installed and configured. Because this installation procedure must not be
interrupted, you should set a side enough time for it to be fully completed and
connect the notebook to the mains outlet using the mains adapter.
During installation, the notebook must only be rebooted when you are requested to do so!
You w ill be prompted to create a backup copy of the pre-installed operating system. This
backup copy can be used later to restore y our notebook to its d elivery configuration.
We strongly recommend that, as soon as possible after purchasing
your equipm ent, you create a backup copy on DVD of the pre-installed
operating system in its delivery configuration.
If you have forgotten an operating system password which has been assigned , without
previously having saved the operating s ystem, recreation of the necessary data
media a nd return to the factory defau lt setup will no longer be possible.
You can find further information on how to restore the operating system, drivers,
manuals and special software in the "Recovery P rocess" manual.
You r operating system is pre-installed on the hard disk to help you when you
start using your notebook for the first time.
1
► Switch the notebook on (1).
► During installation, follow the on-screen instructions.
Consult the operating syste m manual if anything is unclear about the requested input data.
If a Windows opera ting system is installed on your notebook, you will find more
information on the system and drivers, help programs, updates, manuals etc. on
the notebook or on the Interne t under "http: //ts.fujitsu.com/support".
10601087302, edition 1 English - 9
To Next Page
Loading...
Need help?
General