En-3
NAME OF PARTS
Fig. 1 Indoor Unit
1 Intake Grilles
2 Open Grille
3 Indicator
4 Remote Control Signal Receiver (Fig. 2)
5 OPERATION Indicator Lamp
6 TIMER Indicator Lamp
7 UV AIR CLEAN/ANION Indicator Lamp
8 OUTDOOR TEMP/ROOM TEMP. Indicator
Lamp
9 HI-POWER OPERATION Indicator Lamp
0 MAINTENANCE Indicator Lamp
A Air Flow Direction Louver
B Right-Left Louver
(behind Air Flow Direction Louver)
C Power Diffuser
D Anion Generator
E Front Panel (Fig. 3)
F MAINTENANCE/MANUAL AUTO button
G Air Filter
H Dust Box
I Power Supply Cord
J Power Supply Plug
Fig. 4 Outdoor Unit
K Intake Port
L Outlet Port
M Pipe Unit
N Drain Port (bottom)
Fig. 5 Remote Control Unit
O Signal Transmitter
P Remote Control Unit Display
Q Transmit Indicator (Fig. 6)
R Clock/OFF TIMER Display
S ON TIMER Display
T SWING Display
U Operating Mode Display
V Temperature Display
W ECONOMY Operation
X FAN CONTROL Display
Y AIR CLEAN Display
Z COIL DRY Display
[ AIR CLEAN button
\ SET TEMP. button
] SLEEP button
` START/STOP button
a MONITOR button
b COIL DRY button
c FILTER MAINTENANCE button
d MASTER CONTROL button
e FAN CONTROL button
f ECONOMY Operation button
g OFF TIMER button
h ON TIMER button
i SET TIME buttons (+/-)
j SET (TIMER) button
k CANCEL (TIMER) button
l HI-POWER Operation button
m SWING button
n AIR DIRECTION (Left-Right) button
o AIR DIRECTION (Up-Down) button
p TIME ADJUST button (Fig. 7)
q All Clear button
(Located inside battery compartment)
r TEST RUN button
s FILTER MAINTENANCE Interval Switch
9312556014-En.pm6.5 2003.6.11, 5:08 PM3
To Next Page
Loading...
Need help?
General
