En-5
Turn on the Power
Connect the Power Supply Plug (Fig. 1 J) to an electrical outlet;
in the case of a direct line connection, turn on the circuit breaker.
Load Batteries (LR03
××
××
× 2)
1
Press and slide the battery compartment lid on the re-
verse side to open it.
Slide in the direction of the arrow while pressing the mark.
2
Insert batteries.
Be sure to align the battery polarities (+/-) correctly.
3
Close the battery compartment lid.
Set the Current Time
1
Press the SET (TIMER) button (Fig. 5 j)
Use the tip of a ball-point pen or other small object to press the button.
2
Use the +/- SET TIME buttons (Fig. 5 i)to adjust
the clock to the current time.
+ button: Press to advance the time.
- button: Press to reverse the time.
(Each time the buttons are pressed,the time will be advanced/reversed in
one-minute steps.hold the buttons depressed to change the time quickly
in ten-minute steps.)
3
Press the SET (TIMER) button.
This completes the time setting and starts the clock.
To Use the Remote Control Unit
● The Remote Control Unit must be pointed at signal receiver (Fig. 2 4) to operate
correctly.
● Operating Range: About 7 meters.
● When a signal is properly received by the air conditioner, a beeping sound will
be heard.
● If no beep is heard, press the Remote Control Unit button again.
Remote Control Unit Holder
CAUTION!
● Take care to prevent infants from
accidentally swallowing batteries.
● When not using the Remote Control Unit
for an extended period, remove the
batteries to avoid possible leakage and
damage to the unit.
● If leaking battery fluid comes in contact
with your skin, eyes, or mouth, immedi-
ately wash with copious amounts of
water, and consult your physician.
● Dead batteries should be removed
quickly and disposed of properly, either
by placing in a public battery collection
receptacle, or by returning to appropriate
authority.
● Do not attempt to recharge dry batteries.
Never mix new and used batteries, or
batteries of different types.
Batteries should last about one year
under normal use. If the Remote Con-
trol Unit’s operating range becomes ap-
preciably reduced, replace the batteries
and press the ACL button with the tip of
a ballpoint pen or other small object.
1Mount the Holder. 2Set the Romote Control
Unit.
3To remove the Remote Con-
trol Unit (when use hand).
Screws
Insert
Press in
Slide up
Pull out
9312556014-En.pm6.5 2003.6.11, 5:08 PM5
To Next Page
Loading...
Need help?
General
