03-04
(1) Press the START/STOP ( ) button until only the clock is displayed
on the remote controller display.
(3) Press the SET TEMP. ( / ) buttons to change the
signal code between .
Match the code on the display to the air conditioner signal code.
Selecting the Remote Controller Signal Code
(2) Press the MODE button for at least 5 seconds to display the current
signal code (initially set to ).
(4) Press the MODE button again to return to the clock display.
The signal code will be changed.
If no buttons are pressed within 30 seconds after the signal code is displayed,
the system returns to the original clock display. In this case, start again from step 1.
The air conditioner signal code is set to A prior to shipment.
Use the following steps to select the signal code of the remote controller.
( Note that the air conditioner cannot receive a signal code if the
air conditioner has not been set for the signal code.)
To Next Page
Loading...
