Remote switch setting
• Remote controller address setting (SW3)
This switch can be used when group control system. Set the remote controller address in the
1,2,-,15 order.
SW3 SW state Factory setting
0 Single ♦
1—15 Remote controller address
Jumper wire setting
• JM1 and JM2 setting prohibited
• Fan delay setting (JM3)
→hen the indoor unit is stopped while operating in conjunction with auxiliary heater, the indoor
unit fan operation will continue for one minute.
JM3 JM state Factory setting
Connect Disable ♦
Disconnect Enable
1-1. Function settings on indoor unit - (05-2) - 1. Function settings for indoor unit
FIELD
WORKING
FIELD
WORKING
To Next Page
Loading...
