To Next PageTo Next Page
Need help?Do you have a question about the Fujitsu AS G07LUCA Series and is the answer not in the manual?
General| Cooling Capacity | 2.0 kW |
|---|---|
| Heating Capacity | 2.5 kW |
| Refrigerant | R32 |
| Power Supply | 220-240V, 50Hz |
| Operating Temperature (Heating) | -15°C to 24°C |
Controls compressor frequency based on indoor unit, temperature, and outdoor conditions.
Automatically switches between Heating, Cooling, Dry, and Monitoring modes based on temperature.
Details fan speed settings for various models and operation modes.
Explains vertical and horizontal louver adjustments and swing operations for different unit types.
Shows fan speed for outdoor units in Cooling and Heating modes.
Details compressor operation frequency ranges and startup control.
Covers Wireless and Wired remote controller timer settings like ON/OFF, Program, and Sleep timers.
Explains how the electronic expansion valve's opening is calculated and controlled.
The compressor will not operate for 3 minutes after being stopped.
Describes the 4-way valve switching sequence when changing from Cooling to Heating mode.
Memorizes operation settings during power interruption and resumes automatically after power recovery.
Initiates manual auto operation by pressing the MANUAL/AUTO button for a specific duration.
Heats the compressor when outdoor temperature is low to ensure quick warm air discharge.
Operates at maximum power for quick cooling or warming, with automatic turn-off conditions.
Performs heating operation at a minimum temperature setting of 10°C.
Reduces operation output to approximately 70% of normal for energy saving.
Operates the fresh air fan motor in synchronization with the indoor fan.
Controls the external electrical heater operation based on specific conditions.
Details the drain pump operation logic during Cooling/Dry and Heating/Fan modes.
Explains the conditions for starting and completing defrost operations.
Lists error codes and their corresponding indicator patterns on indoor and remote controllers.
Provides step-by-step troubleshooting procedures for specific error codes.
Offers troubleshooting steps for issues without specific error codes.
Lists parts and diagnostic procedures for troubleshooting various components.
Diagnosis methods and replacement procedures for compressor issues.
Checks connections, coil resistance, voltage, noise, and valve operation for EEV.
Details how to check the discharge pressure sensor's connection, characteristics, and voltage.
Procedures for checking fan rotation and resistance, and replacing the motor or PCB.
Steps for checking fan rotation and resistance, and replacing the motor or Main PCB.
Instructions for checking the active filter module for open/short circuits and output voltage.
Steps for checking the IPM module for resistance and diode characteristics.
Important cautions and procedures when replacing the outdoor unit's Main PCB.
