7
To Stop Operation
Press the START/STOP button (Fig. 6 Q).
The OPERATION Indicator Lamp (red) (Fig. 3 5) will go out.
About AUTO CHANGEOVER Operation
AUTO: ● When AUTO CHANGEOVER operation fi rst selected, the fan will operate at
very low speed for about a few minutes, during which time the indoor unit
detects the room conditions and selects the proper mode.
Room temperature is higher than the defi ned temperature in temperature
setting → Cooling mode or dry mode
Room temperature is close to or lower than the defi ned temperature in
temperature setting → Monitor operation
● When the indoor unit has adjusted your room’s temperature to near the
temperature setting, it will begin monitor operation. In the monitor operation
mode, the fan will operate at low speed. If the room temperature subsequently
changes, the indoor unit will once again select the appropriate operation
(Cooling) to adjust the temperature to the value set in the temperature set-
ting.
● If the mode automatically selected by the unit is not what you wish, select
one of the mode operation (COOL, DRY, FAN).
About Mode Operation
Cooling: ● Use to cool your room.
Dry: ● Use for gently cooling while dehumidifying your room.
● You cannot heat the room during Dry mode.
● During Dry mode, the unit will operate at low speed; in order to adjust room
humidity, the indoor unit’s fan may stop from time to time. Also, the fan may
operate at very low speed when adjusting room humidity.
● The fan speed cannot be changed manually when Dry mode has been
selected.
Fan: ● Use to circulate the air throughout your room.
During Cooling/Dry mode:
Adjust the temperature setting that is lower
than the current room temperature. The
Cooling and Dry modes will not operate if
the temperature is set higher than the actual
room temperature (in Cooling mode, the fan
alone will operate).
During Fan mode:
You can not use the unit to heat and cool
your room.
Defi ned
temperature in
temperature
setting
Cooling mode
or Dry mode
Monitor operation
9315345462_OM.indb 79315345462_OM.indb 7 6/23/2011 9:06:01 AM6/23/2011 9:06:01 AM
To Next Page
Loading...
