( .Cleaning
the
dust collection unit J
4.
Install the unit.
(The above figure is only
for
reference, so the intake grille
is
not included.)
CD
Align
the
two
ends
of
the dust collection
unit
with
the guide rail and slide in.
Guide rail
® Slide in until
it
clicks.
• Please ensure
that
the dust collection unit is
completely
dry
before installing .
•
After
installing
the
dust
collection
unit,
please
ensure that
it
has been inserted
fully
into its place.
If
it
has
not
been installed correctly, the
OPERATION
indicator
lamp
(red) and the TIMER indicator lamp
(green)
will
flash, and
Air
Cleaning
will
stop.
5.
Install the air filter.
• Please consult instructions
for
cleaning the air filter
on page
12.
6.
Close
the intake grille.
Push
the
intake grill in at 4 points (the
two
ends
of
its
lower side as well
as
two
center points
of
the lower side,
as
shown in the figure) to close it.
Please ensure that the intake grille is
closed properly.
• If,
after
cleaning
the
dust
collection
unit,
the
operation indicator
lamp
and
the
timer
indicator
lamp flash during
Air
Cleaning, please ensure that
the
unit
is
not
damp
and
that
the
intake
grille
is
properly
Closed
.
• If, after having checked
that
the
unit
is
fully
dry and
that the intake grille is closed properly, the indicator
lamps continue
to
flash, the dust collection unit may
be damaged. Please consult
an
authorised dealer
to obtain a replacement.
~
WARNING!
.Be
sure
the
Intake
Grille
(Fig. 1 ®)
is
installed
securely .
En-14
To Next Page
Loading...
Need help?
General
