To Next Page

To Previous Page

STEP 2: Selecting the function number and setting value

1. Press the TEMP./SELECT ( ) ( ) buttons to select the function

number. To switch between the left and right digits, press the MODE

button.

2. Press the FAN SPEED button to proceed the setting value. To re-

turn the function number selection, press the FAN SPEED button

again.

3. Press the TEMP./SELECT (

) ( ) buttons to select the setting val-

ue. To switch between the left and right digits, press the MODE but-

ton.

4. Press the TIMER button, and when the indoor unit beeps, press the

(START/STOP) button to confirm the settings.

5. Press the RESET button to cancel the function setting mode.

6. After completing the function setting, be sure to disconnect the pow-

er supply and then reconnect it.

Function number

Setting value

CAUTION

• After disconnecting the power supply, wait 30 seconds or more before reconnecting it. The func-

tion setting will not become active unless the power supply is disconnected and then reconnect-

ed.

• When using a custom code other than A, press [RESET] and then press and hold [MODE] again

for 5 seconds or more to set the custom code.

1-1. Function settings by using remote controller - (05-2) - 1. Function settings

FIELD

WORKING

FIELD

WORKING

Fujitsu ASUH24LPAS Service Manual

Other manuals for Fujitsu ASUH24LPAS