Fujitsu D1271 - Layout Contents

D1271/D1291 CUV-LSV/CUV-LV User’s Manual 15
3. HARDWARE SETUP
3.2 Layout Contents
Motherboard Settings
1) JEN p. 17 JumperFree Mode Setting (Disable/Enable)
2) DIP_SW 5–8 p. 18 CPU External Frequency Selection
3) DIP_SW 1-4 p. 19 CPU Core:BUS Frequency Multiple Selection
4) R56 p. 21 Clear RTC RAM
5) LAN-EN p. 21 LAN Setting
6) SCSI_EN p. 22 SCSI Setting (optional)
Expansion Slots/Sockets
1) DIMM 1/2/3/4 p. 24 DIMM Support
2) Socket 370 p. 25 CPU Support
3) PCI 1/2/3/4 p. 27 32-bit PCI Bus Expansion Slots
Connectors
1) PS2KBMS p. 29 PS/2 Mouse Port (6 pin-female)
2) PS2KBMS p. 29 PS/2 Keyboard Port (6-pin female)
3) USB p. 30 Universal Serial Bus Ports1 & 2 (Two 4-pin female)
4) PRINTER p. 30 Parallel Port (25-pin female)
5) COM1/COM2 p. 30 Serial Ports (9-pin /10-1 pin male)
6) VGA p. 31 Monitor Output Port (15-pin female)
7) RJ-45 p. 31 Fast Ethernet LAN Connectors (Two RJ-45)
8) HDLED p. 32 IDE and SCSI Activity LED (2-pin)
9) FLOPPY p. 32 Floppy Disk Drive Port Connector (34 pins)
10) PRIMARY IDE p. 33 IDE Connectors (Two 40-1 pins)
SECONDARY IDE
11) CHA/CHB p. 34 Ultra160 Wide SCSI Connectors (Two 68-pin)
12) WOL_CON p. 35 Wake-On-LAN Connector (3-pin)
13) WOR p. 35 Wake-On-Ring Connector (2-pin)
14) PWR/CPU/CHA_FAN p. 36 Power, CPU, and Chassis Fan Connectors (Three 3-pin)
15) USBPORT p. 36 USB2 Header (10-1 pins)
16) IR p. 37 Infrared Module Connector (5-pin)
17) CHASSIS p. 37 Chassis Intrusion Lead (2-pin)
18) ATXPWR p. 38 ATX Power Supply Connector (20 pins)
19) SMB/BP_SMB p. 38 SMBus Connectors (Two 5-1 pins)
20)
PWR.LED ( PANEL ) p. 39 System Power LED Lead (3-pin)
21) SPEAKER (PANEL) p. 39 System Warning Speaker Connector (4-pin)
22) MSG.LED (PANEL) p. 39 System Message LED (2-pin)
23) SMI (PANEL) p. 39 System Management Interrupt Lead (2- pin)
24) PWR.SW (PANEL) p. 39 ATX / Soft-Off Switch Lead (2-pin)
25) RESET (PANEL) p. 39 Reset Switch Lead (2-pin)
Layout Contents
3. H/W SETUP