D1271 / D1291 CUV-LSV / CUV-LV User’s Manual62
4. BIOS SETUP
4. BIOS SETUP
PCI Configuration
ONB SCSI BIOS First [Yes]
When set to [Yes], this field allows the onboard SCSI BIOS to start up before the
PCI devices. When set to [No], the onboard SCSI starts up after all the PCI devices
have been initialized. Configuration options: [No] [Yes]
NOTE: This parameter appears on SCSI models only.
USB Function [Enabled]
Set this field to [Enabled] if you want to use Universal Serial Bus devices.
Configuration options: [Disabled] [Enabled]
Primary VGA BIOS [PCI Card]
This field allows you to select the primary graphics card. Configuration options:
[PCI Card] [AGP Card] [On-Board]
Onboard LAN Boot ROM [Disabled]
When set to [Enabled], this field allows the system to boot from a remote server
through the onboard LAN connection. Configuration options: [Disabled] [Enabled]
IRQ XX Used By ISA [No/ICU]
These fields indicate whether or not the displayed IRQ for each field is being used
by a legacy (non-PnP) ISA card. The setting [No/ICU] for an IRQ field indicates
that you are using the ISA Configuration Utility (ICU), and that this particular IRQ
is NOT required by a legacy ISA card. Set the IRQ field to [Yes] if you install a
legacy ISA card that requires a unique IRQ and you are NOT using ICU. Configuration
options: [No/ICU] [Yes]
PCI IRQ Resource Exclusion
To Next Page
Loading...
