Fujitsu D1271 - Page 21

D1271/D1291 CUV-LSV/CUV-LV User’s Manual 17
3. HARDWARE SETUP
Motherboard Frequency Settings (DIP Switches - DIP_SW)
The motherboard frequency is adjusted through the DIP switches. The white block
represents the switch’s position. The example below shows all the switches in the
OFF position.
1) JumperFree™ Mode (JEN)
This jumper allows you to enable or disable the JumperFree™ mode. The
JumperFree™ mode allows processor settings to be made through the BIOS
setup (see 4.4 Advanced Menu).
Setting JEN
Enable (JumperFree) [2-3] (default)
Disable (Jumper) [1-2]
NOTE: In JumperFree™ mode, set all DIP switches (DIP_SW) to OFF.
3. H/W SETUP
Motherboard Settings
CUV-LSV DIP Switches
ON
12345678
OFF
ON
< Frequency Multiple
< Frequency Multiple
< Frequency Multiple
< Frequency Multiple
< Frequency Selection
< Frequency Selection
< Frequency Selection
< Frequency Selection
CUV-LSV
CUV-LSV
CUV-LSV JumperFree™ Mode Setting
Jumper Mode JumperFree Mode
(Default)
JEN
ON
12345678
OFF
DIP_SW
2
3
1
2