Power M en u – Energy saving functions
Power Menu – Energy saving func
tions
Power
Item Specific Help
Power-on Source: [BIOS Controlled]
LAN:
[Enabled]
Wake Up Timer:
[Disabled]
Wake Up Time:
[00.00.00]
Wake Up Mode:
[Daily]
Power Failure Recovery: [Previous State]
[BIOS Controlled]
Power-on sources
are controlled by BIOS
Also valid for ACPI
operating systems.
[ACPI Controlled]
Power-om source are
controlled by an ACPI
operating system.
Wake On LAN boot:
[Boot Sequence]
Low Power Soft Off: [Disabled]
USB At Power-off: [Always Off]
USB Keyboard: [Disabled]
Hibernate like Soft Off: [Disabled]
Example showing t
he Power menu
Power On Source – Management of switch-on sources
Specifies whet her the switch-on sources for ACPI operating systems are managed
by the BIOS or the operating system.
BIOS
Controlled
The switch-on sources are managed by the BIOS.
ACPI Controlled
The switch-on sources are managed by the ACPI operating system.
Power On Source: LAN – Switch on via LAN controller
Systempower-on
Determines whether the system can be switche d on via a LAN controller (on
the mainboard or additional board).
Enabled The system can be switched on via a LAN con troller.
Disabled
The syste m cannot be switched on via a LAN controller.
Wake On LAN Boot – Switching on over the network
Switc
hons ystem
Specifies the system behaviour when switched on by means of network signals.
Boot
Sequence
The system boots up according to the device s equence specified in the Boot m enu
when switched on via LAN.
Force LAN
Boot
The system is booted remotely via LAN when switched on via LAN.
58 Fujitsu Technology Solutions
To Next Page
Loading...
