Fujitsu KVM s4-0812 User Manual

Quick Installation Guide
Fujitsu Technology Solutions GmbH, User Documentation, 33106 Paderborn, Germany • Email - manuals@ts.fujitsu.com l Online - http://ts.fujitsu.com/support
All hardware and software names used are trademarks of their respective manufacturers. 590-1057-640A
installation
4
KVM s4 Switch
KVM s4-0812
|
KVM s4-1622
|
KVM s4-3242
The following instructions will help you install
and use your switch easily.
Should you require further assistance, please
consult your installer/user guide.
1
Connecting the local port
Connect your VGA monitor and USB keyboard and
mouse cables into the appropriate ports on the KVM
s4 switch.
2
Connecting a CAT 5 adapter cable to
the KVM s4 switch
Connect one end of a CAT 5 cable (4-pair, up to 150 ft/45 m)
into an available numbered port on the rear of
your switch. Connect the other end into the RJ-45
connector of the CAT 5 adapter cable.
3
Connecting a target device to a CAT
5 adapter cable
Connect a CAT 5 adapter cable into the appropriate
port on the back of a target device. Repeat steps 2
and 3 for all target devices you want to connect.
4
Connecting network users
Connect a customer supplied CAT 5 cable from the
Ethernet network into a LAN port on the back of
the switch. Network users will access the switch
through this port.
5
Connecting to an external modem
(optional)
The switch may also be accessed using an ITU V.92,
V.90 or V.24-compatible modem. Connect one end of
a CAT 5 cable into the MODEM port on the switch.
Connect the other end into the CAT 5 to DB-9 (male)
adapter, which then connects into the appropriate
port on the back of the modem.
KVM s4 switch conguration
Telephone
network
Target
devices
2
1
KVM s4 Switch
(KVM s4-3242 shown)
Ethernet
Modem
CAT 5
Adapters
3
4
Local USB Connections

Fujitsu KVM s4-0812 Specifications

General

Device Type	KVM Switch
Model	s4-0812
Category	Switch
Ports	8
Resolution	1600 x 1200
Interface	PS/2

Summary

KVM s4 Switch Installation Guide

Connecting Local and Network Ports

Connect VGA, USB, CAT 5 cables, and network users to the switch.

External Modem Connection

Optional connection for modem access to the KVM s4 switch.

Connecting Optional Peripherals and Power

Connecting Supported PDU and Virtual Media

Connect PDUs, virtual media devices, or smart card readers to the switch.

Powering On Target Devices and Switch

Turn on target devices and connect redundant power cords to the switch.

Safety Precautions and Procedures

Electrical Safety and Shock Prevention

Guidelines to prevent electrical shock during installation and operation.

Connection and Disconnection Procedures

Step-by-step instructions for connecting and disconnecting cables.

Rack-Mounting Safety Considerations

Factors to consider for safe and proper equipment installation in a rack.

Rack Mounting Instructions

Vertical Rack Installation

Steps for mounting the switch vertically in a rack using L-shaped brackets.

Horizontal Rack Installation

Steps for mounting the switch horizontally in a 1-U rack space.

Safety, EMC, and Environmental Approvals

Information on product certifications and compliance markings.