Need help?Do you have a question about the Fujitsu PSWITCH 2048T and is the answer not in the manual?
General| Switching Capacity | 176 Gbps |
|---|---|
| Forwarding Rate | 131 Mpps |
| MAC Address Table Size | 16K |
| VLAN Support | Yes |
| PoE | No |
| Power Consumption | 40W |
Provides instructions on how to install the switch unit into a standard 19-inch rack.
Procedure for connecting a console device to the switch for initial configuration.
Explains how to access the switch remotely using the management port via Telnet or SSH.
Covers initial setup steps like checking version, setting clock, and port configuration.
Details the supported protocols (CLI, SNMP, NETCONF, OVSDB) for managing the switch.
Covers Layer 2 switching features like port configuration, MAC tables, VLANs, and LAGs.
Covers IP addressing, IPv6 routing and management, and ICMP protocol functionalities for network communication.
Enables high availability, low latency, and loss-less Ethernet service using DCBX, ETS, PFC, and Application Priorities.
Monitors DHCP messages between clients and servers to filter harmful messages and build a bindings database.
Manages user access via local or remote servers (RADIUS, TACACS+, LDAP) with privilege levels 0, 1, and 15.
Details authentication types (login, enable, dot1x) and methods (local, RADIUS, TACACS+, LDAP, ias).
Restricts access to LAN services based on physical characteristics of LAN infrastructure for authentication.
Simplifies user authentication via a single database (Authentication Server) using the RADIUS protocol.
Provides access control using TACACS+, supporting separate authentication, authorization, and accounting services.
Integrates LDAP client for user authentication via username and password with an LDAP server.
To Next Page
