Fujitsu PSWITCH 2048T - Tagging VLAN; Link Aggregation; Static LAG

FUJITSU PSWITCH User’s Guide
144 December/2018
[Conditions]
Assign VLAN 10 without tag to port 0/1.
Assign VLAN 20 without tag to port 0/5.
[Commands]
(Hostname) #vlan database
(Hostname) (Vlan)#vlan 10,20
(Hostname) (Vlan)#exit
(Hostname) #configure
(Hostname) (Config)#interface 0/1
(Hostname) (Interface 0/1)#switchport mode access
(Hostname) (Interface 0/1)#switchport access vlan 10
(Hostname) (Interface 0/1)#exit
(Hostname) (Config)#interface 0/5
(Hostname) (Interface 0/5)#switchport mode access
(Hostname) (Interface 0/5)#switchport access vlan 20
(Hostname) (Interface 0/5)#exit
3.2.1.2. tagging VLAN
This section explains how to set up when sending and receiving tagged packets
from two VLANs in each VLAN on one port.
[Conditions]
Assign VLAN 10 with tagging to port 0/1.
Assign VLAN 20 with tagging to port 0/5.
[Commands]
(Hostname) #vlan database
(Hostname) (Vlan)#vlan 10,20
(Hostname) (Vlan)#exit
(Hostname) #configure
(Hostname) (Config)#interface 0/1
(Hostname) (Interface 0/1)#switchport mode trunk
(Hostname) (Interface 0/1)#switchport trunk allowed vlan 10,20
(Hostname) (Interface 0/1)#exit
3.2.2. Link aggregation
3.2.2.1. static LAG
This section explains how to set up link aggregation for two-port circuits.
[Conditions]
Set ports 0/17-0/18 as link aggregation.