Fujitsu PSWITCH 2048T User Manual

User’s Guide FUJITSU PSWITCH
December/2018 147
[Commands]
(Hostname) #vlan database
(Hostname) (Vlan)#vlan 10
(Hostname) (Vlan)#exit
(Hostname) #configure
(Hostname) (Config)#interface 0/6-0/14
(Hostname) (Interface 0/6-0/14)#switchport access vlan 10
(Hostname) (Interface 0/6-0/14)#spanning-tree port mode
3.2.6. Port mirroring
By using the port mirroring function, it is possible to monitor the reception /
transmission traffic of the specified source port from the specified target port.
[Conditions]
Set the interface 0/1 port as the source port.
Set the interface 0/19 port as the target port.
[Commands]
(Hostname) #configure
(Hostname) (Config)#monitor session 1 source interface 0/1
(Hostname) (Config)#monitor session 1 destination interface 0/19
(Hostname) (Config)#monitor session 1 mode
3.2.7. LLDP function
[Conditions]
Enables the sending and receiving of LLDP in port 0/15.
[Commands]
(Hostname) #configure
(Hostname) (Config)#interface 0/15
(Hostname) (Interface 0/15)#lldp transmit
(Hostname) (Interface 0/15)#lldp receive
(Hostname) (Interface 0/15)#exit
3.2.8. SNMP agent function
This device supports Simple Network Management Protocol (SNMP) agent function.
This section explains how to set the MIB information when notifying the SNMP
host.
[note] The MIB of VXLAN is not supported with this device.

Fujitsu PSWITCH 2048T Specifications

General

Brand	Fujitsu
Model	PSWITCH 2048T
Category	Switch
Language	English