Fujitsu PSWITCH 2048T - Physical_Port Table; Tunnel Table; Logical_Switch Table

FUJITSU PSWITCH User’s Guide
44 December/2018
tunnels: Tunnels created by this switch as instructed by the NVC. Each of column maps to
rows of tunnel table.
Group: Network Status
management_ips: The switch management IPv4 or IPv6 addresses.
tunnel_ips: The switch VTEP IPv4 addresses.
Group: Identification.
name: Symbolic name for the switch. It’s the switch host name.
description: An extended description for the switch. It’s the CLI login banner.
Physical_Port Table
This table maintains switch’s port and VLAN binding configuration.
Column:
van_bindings: Identifies VLAN on the physical port is bound to logical switch.
Group: Identification.
name: Symbolic name for the physical port. The port name must be switch physical or
trunk port name.
description: An extended description for the physical port.
Tunnel Table
This table maintains tunnels created by physical_switch. Multiple logical switches
utilize tunnel specified by local and remote tunnel end-points. If a tunnel does not
added to any logical switch, this row will be removed from tunnel table.
Column:
local: Tunnel end-point local to the physical switch. This column maps to a row of
physical_locator.
remote: Tunnel end-point remote to the physical switch. This column maps to a row of
physical_locator.
Logical_Switch Table
This table maintains logical VXLAN switch.
Column:
local: Tunnel end-point local to the physical switch. This column maps to a row of
physical_locator.
remote: Tunnel end-point remote to the physical switch. This column maps to a row of
physical_locator.