User’s Guide FUJITSU PSWITCH
December/2018 129
on the local subnet and the routing interface to that subnet is up. With this product,
you can set static reject routes. Packets matching a reject route are discarded. You
can set the following route types in the routing table:
Default:
The default route is the route that the switch uses to send packets if it does not
contain a prefix that matches the packet's destination longer than the packet's
destination in the routing table.
Static:
A static route is a route that you add manually to the routing table.
Static Reject:
Packets that match reject routes are discarded, not forwarded. The router may
send an ICMP destination unreachable message.
3.1.9.13. Route Redistribution
This product supports route redistribution between routing protocols. Network
administrators may redistribute configured static routes or directly connected routes into
specific protocols. The following table shows the route redistribution supported by IP and
IPv6.
To Next Page
Loading...
Need help?
General
