Fujitsu PSWITCH 2048T User Manual

FUJITSU PSWITCH User’s Guide
146 December/2018
SW2
(SW2) #configure
(SW2) (Config)#feature vpc
(SW2) (Config)#vpc domain 1
(SW2) (Config-VPC 1)#peer detection enable
(SW2) (Config-VPC 1)#peer-keepalive enable
(SW2) (Config-VPC 1)#exit
(SW2) (Config)#interface 0/2-0/3
(SW2) (Interface 0/2-0/3)#addport lag 2
(SW2) (Interface 0/2-0/3)#interface lag 2
(SW2) (Interface lag 2)#vpc peer-link
(SW2) (Interface lag 2)#interface 0/1
(SW2) (Interface 0/1)#addport lag 1
(SW2) (Interface 0/1)#interface lag 1
(SW2) (Interface lag 1)#vpc 1
3.2.4. Packet Filtering Function
Specify the MAC address and IP address in the ACL.
[Conditions]
Allow only packets from specific MAC address
[Commands]
(Hostname) #configure
(Hostname) (Config)#mac access-list extended mac1
(Hostname) (Config-mac-access-list)#permit 00:00:00:00:aa:bb ff:ff:ff:ff:00:00 any
(Hostname) (Config-mac-access-list)#exit
[Conditions]
Only packets from specific IP addresses are blocked.
[Commands]
(Hostname) #configure
(Hostname) (Config)#ip access-list ip1
(Hostname) (Config-ipv4-acl)#deny 192.168.1.100 any
(Hostname) (config-ip-list)# exit
3.2.5. STP
In this switch, STP is enabled by default. So, there is no need to make settings to
enable STP. If STP was disabled for some reason, to make STP enabled, do following
settings.
[Conditions]
Set the interfaces 0/6 to 0/14 port as the port VLAN of VID 10 and enable STP.

Fujitsu PSWITCH 2048T Specifications

General

Brand	Fujitsu
Model	PSWITCH 2048T
Category	Switch
Language	English