Problem Possible Cause Possible Solution
Shutdown and Startup Problems
The Suspend/
Resume button
does not work.
The Suspend/Resume
button is disabled from the
Advanced submenu of the
Power menu of the setup
utility.
Enable the button from the setup utility.
You did not hold the button
in long enough.
Hold the button longer. This may need to be a
few seconds if your application is preventing
the CPU from checking for button pushes.
There may be a conflict
with the application
software.
Close all applications and try the button again.
The system
powers up, and
displays power on
information, but
fails to load the
operating system.
The boot sequence
settings of the setup utility
are not compatible with
your configuration.
Set the operating source by pressing the
[ESC] key while the Fujitsu logo is on screen
or use the [F2] key and enter the setup utility
and adjust the source settings from the Boot
menu.
You have a secured
system requiring a
password to load your
operating system.
Make sure you have the right password. Enter
the setup utility and verify the Security settings
and modify them as accordingly.
Internal hard drive was
not detected.
Use the BIOS setup utility or Primary Master
submenu, located within the Main menu, to try
to auto detect the internal hard drive.
An error message
is displayed on the
screen during the
notebook (boot)
sequence.
Power On Self Test
(POST) has detected a
problem.
See the Power On Self Test (POST)
messages to determine the meaning and
severity of the problem.
Not all messages are errors; some are simply
status indicators.
To Next Page
Loading...
