66
- Memory Upgrade Module
6 Align the memory upgrade module with the component side up. Align the connector edge of the memory
upgrade module with the connector slot in the compartment. The connector will be pointing toward the rear of
the notebook.
7 Insert the memory upgrade module at a 45° angle. Press the connector edge of the module firmly down and into
the connector until it lodges under the retaining clip. You will hear a click when it is properly in place. (Figure 38)
8 Replace the cover by hooking the tabs under the rear edge of the compartment opening and tilting down until
flush with the bottom of your notebook. Replace the screws.
Figure 37. Opening the Memory Compartment Figure 38. Installing a Memory Upgrade Module
T
HE MEMORY UPGRADE MODULE IS NOT SOMETHING YOU SHOULD ROUTINELY REMOVE FROM YOUR NOTEBOOK. ONCE IT IS INSTALLED, YOU SHOULD
LEAVE IT IN PLACE UNLESS YOU WANT TO INCREASE SYSTEM MEMORY CAPACITY.
To Next Page
Loading...
