67
- Memory Upgrade Module
Checking the Memory Capacity
Once you have changed the system memory capacity by replacing the installed module with a larger one, be sure to
check that your notebook has recognized the change.
Removing a Memory Upgrade Module
1 Perform steps 1 through 5 of Installing a Memory
Upgrade Module.
2 Pull the clips sideways away from each side of the
memory upgrade module at the same time.
3 While holding the clips out, remove the module
from the slot by lifting it up and pulling towards
the rear of your LIFEBOOK notebook. (Figure 39)
4 Store the memory upgrade module in a static
guarded sleeve.
5 Replace the cover by following step 8 of Installing
a Memory Upgrade Module.
Figure 39. Removing a Memory Upgrade Module
A
FTER INSTALLING YOUR ADDED MEMORY MODULE, YOU MUST RESET THE POWER PLAN PARAMETERS IN ORDER FOR THE SAVE-TO-DISK MODE TO
OPERATE PROPERLY ON YOUR LIFEBOOK NOTEBOOK.
S
EE
“H
IBERNATION
(S
AVE
-
TO
-D
ISK
) F
EATURE
”
ON
PAGE
41.
To Next Page
Loading...
