13. Turn the Display back and lay it
down.
15. Extract 2 screws from the Display
hinge.
17. Extract 4 screws from the upper
case and open the external VGA
connector cover.
19. Lift off the upper case.
14. Disconnect 2 Display cables from
the system board and the 2 antenna
cables from the WLAN Card.
16. Lift the Display off the lower
assembly.
18. Disconnect the ClickPoint button
cable and the speaker cable from
the system board.
20. Extract 1 screw from the WLAN
card and lift it out.
To Next Page
Loading...
