109
WIreless LAN User’s Guide
Communication
is disconnected
soon after
connection to
the access point
Access control may be
disabled
In case of Windows XP, check the setting of “Enable network access
control using IEEE 802.1X”.Refer to “Assigning parameters” on
page 97.
When restricting the access of wireless LAN clients using IEEE802.1X
authentication, put a check mark on “Enable network access control
using IEEE 802.1X”.
When using at home, remove a check mark on “Enable network access
control using IEEE802.1X”.
For the method of setting related with IEEE802.1X authentication, refer
to the access point manual.
Problem Possible Cause Possible Solution
S Series.book Page 109 Thursday, February 19, 2004 4:52 PM
To Next Page
Loading...
