Fujitsu Lifebook T4310 - Page 38

38 - Display Panel
Enabling/Disabling Ambient Light Sensor
<RXUFRPSXWHUKDVDQDPELHQWOLJKWVHQVRUMXVWEHORZWKH3RZHU6XVSHQG5HVXPHVZLWFKWKDW
DXWRPDWLFDOO\VHQVHVWKHOLJKWFRQGLWLRQVLQZKLFKWKHFRPSXWHULVRSHUDWLQJ,IWKHOLJKWLQJLVYHU\EULJKW
WKHEULJKWQHVVRIWKH/&'ZLOOLQFUHDVHWRPDNHLWHDVLHUWRVHHWKHGLVSOD\&RQYHUVHO\LILWLVXVHGLQD
GDUNHQHGURRPWKHGLVSOD\ZLOODXWRPDWLFDOO\GLP
7KHOLJKWVHQVRUFDQEHHQDEOHGRUGLVDEOHGIURPWKH&RQWURO3DQHODVIROORZV
1 Open the system Control Panel and click in the View by: field, select either large or small icons.
2 Click on the Location and Other Sensors icon.
3 To enable or disable the Light Sensor utility, check or uncheck the box in the Enabled column.
4 For more information about the light sensor, click on Light Sensor in the Sensor column to open the Sensor
Properties window.
5 From the Sensor Properties window, you can change the sensor’s description, uninstall the sensor, or enable
or disable selected users.
• To change the sensor’s description, click the [Change description] button, enter the new description, and
click the [OK] button.
• To limit who can access the sensors, click Change who can access sensors, then check or uncheck the
box adjacent to the individual you would like to grant or prohibit access.
• To uninstall the sensor, click Uninstall this sensor.
I
F USING AC POWER, YOUR BRIGHTNESS SETTING IS SET TO ITS HIGHEST LEVEL BY DEFAULT. IF USING
BATTERY POWER
, YOUR BRIGHTNESS SETTINGS IS SET TO APPROXIMATELY MID-LEVEL BY DEFAULT.
T
HE HIGHER THE BRIGHTNESS LEVEL, THE MORE POWER THE TABLET PC WILL CONSUME AND THE
FASTER YOUR BATTERIES WILL DISCHARGE
. FOR MAXIMUM BATTERY LIFE, MAKE SURE THAT THE
BRIGHTNESS IS SET AS LOW AS POSSIBLE
.