Fujitsu Lifebook T4310 - Page 50

50 - Touchpad/Active Digitizer/Touchscreen
Calibrating the Active Digitizer Display
,QRUGHUWRHQVXUHDFFXUDWHWUDFNLQJEHWZHHQWKHVW\OXVDQGFXUVRU\RXPXVWUXQWKH&DOLEUDWLRQ8WLOLW\
EHIRUH\RXXVHWKHV\VWHPIRUWKHILUVWWLPHRUDIWHU\RXFKDQJHWKHGLVSOD\UHVROXWLRQ
7RUXQWKHFDOLEUDWLRQXWLOLW\
1 Go to Start -> Control Panel. (On Windows Vista systems, If you are not in Classic View, select “Switch to
Classic View” in the left panel.)
2 Double-click the Tablet PC Settings icon and select the General tab
3 Click the [Calibrate] button.
4 Adjust the display of your Tablet PC to a comfortable angle and find the (+) symbol in the upper-left corner of
the display..
5 Using the stylus, firmly touch the screen directly on the (+) symbol. Lift the stylus from the screen and the target
will move to a different location on the screen.
6 Repeat step 4 until you have selected all of the (+) symbols.
7 Once you have selected all the symbols, press the [OK] button.
8 Touch the stylus to various points on the screen to verify that the screen is correctly calibrated. If you are not
satisfied with the screen’s calibration, press the [Calibrate]) button to begin again.
D
O NOT USE EXCESSIVE FORCE WHEN TAPPING ON THE SCREEN DURING CALIBRATION. USE OF
EXCESSIVE FORCE COULD RESULT IN DAMAGE TO THE
LED AND/OR TOUCH PANEL.