24
Troubleshooting
Problem
Shutdown and Startup Problems
The Suspend/
Resume button
does not work.
The system
powers up, and
displays power on
information, but
fails to load the
operating system.
An error message
is displayed on the
screen during the
notebook (boot)
sequence.
The Suspend/Resume
button is disabled from
the Advanced submenu
of the Power menu of the
setup utility.
The boot sequence
settings of the setup
utility are not compatible
with your confi guration.
Power On Self Test
(POST) has detected a
problem.
You did not hold the
button in long enough.
There may be a conict
with the application
software.
You have a secured
system requiring a
password to load your
operating system.
Internal hard drive was
not detected.
Enable the button from the setup utility.
Set the operating source by pressing the
[ESC] key while the Fujitsu logo is on screen
or use the [F2] key and enter the setup utility
and adjust the source settings from the Boot
menu.
See the Power On Self Test (POST)
messages to determine the meaning and
severity of the problem.
Not all messages are errors; some are simply
status indicators.
Hold the button longer. This may need to be a
few seconds if your application is preventing
the CPU from checking for button pushes.
Close all applications and try the button again.
Make sure you have the right password. Enter
the setup utility and verify the Security settings
and modify them as accordingly.
Use the BIOS setup utility or Primary Master
submenu, located within the Main menu, to try
to auto detect the internal hard drive.
Possible Cause Possible Solution
To Next Page
Loading...
