Fujitsu PlasmaVision P42HHA30WS - Selecting Input Mode; Video and RGB Input Mode Selection

E-14
SELECTING INPUT MODE
RGB INPUT MODE
1
RGB1 mode
Press the –
buttons to
select the input mode.
You can select from VIDEO1 mode to VIDEO4
mode.
The video modes corresponding to each input
terminal are as follows.
•VIDEO1: Video
• VIDEO2: S-video
• VIDEO3: Component video
• VIDEO4: Component video
*For selection of the input terminal, see
“SETTING THE INPUT TERMINALS” on
P. E-29.
1
*You can also use the buttons
on the display’s control
panel to perform these steps.
VIDEO INPUT MODE
Video1 mode
Press
–
to select the
input mode.
You can select between the modes from RGB1 to
RGB2.
The input terminal of each RGB mode is as
follows.
• RGB1: DVI-D
• RGB2: mD-sub
*For selection of the input terminal, see
“SETTING THE INPUT TERMINALS” on
P. E-29.
E-Plasma-wide2(12-18) 03.10.7, 3:06 PMPage 14 AdobePageMaker6.5J/PPC