TX100 S1 Service Supplement 19
Replacement routines Replacing the front panel cable
Figure 3: Removing the front panel
Ê Detach the three unlocking levers.
Ê Fold out the front panel carefully, the hooks on the other side are unlocked.
V CAUTION!
The front panel cable is connected directly to the front panel.
If you are not careful when you open the front panel, you may damage
the front panel cable.
4.2 Replacing the front panel cable
Ê Open the server as described in section “Preparation” on page 17.
Ê Remove the system fan 1 as described in section “Replacing the system
fan 1” on page 27.
To Next Page
Loading...
