26 Service Supplement TX100 S1
Replacing the USB front cable Replacement routines
Figure 10: Removing the USB front cable
Ê Unhook the connector mounting plate and pull out carefully the USB front
cable from the chassis.
Ê Thread the new cable through the recess and engage the connector
mounting plate.
Ê Fasten the connector mounting plate with the screw.
Ê Reconnect the USB front cable T26139-Y3894-V513 to the connector
USB9/10 on the system board.
Ê Close the front panel.
Ê Close the server and reconnect the power plug.
To Next Page
Loading...
