28 Service Supplement TX100 S1
Replacing the system fan 1 Replacement routines
Figure 12: Removing system fan 1
Ê Unhook the system fan 1 by pushing it in the direction marked and take it out
the chassis.
Ê Place the new system fan 1 and push it under the hooks until it engages.
Ê Fasten the system fan with the two screws on the bottom of the server.
Ê Connect the fan cable to the connector FAN1 SYS on the system board.
Ê Reinstall the air duct.
Ê Close the server and reconnect the power plug.
To Next Page
Loading...
