34 Service Supplement TX100 S1
Replacing the power supply unit Replacement routines
– on the side
Figure 19: Chassis - hooks on the side
Ê Insert the pre-mounted power supply unit in the chassis.
I Make sure that the power supply unit engages.
Ê Secure the power supply unit at the rear of the server with the four screws
(see also figure 15 on page 31).
Ê Connect all power supply cables to the system board and to the drives (see
the cabling in the Options Guide).
Ê Close the server and reconnect the power plug.
To Next Page
Loading...
