14 Options Guide TX100 S1
Safety instructions
V CAUTION!
● Proper operation of the device (in accordance with
IEC 60950-1/EN 60950-1) is only ensured if the casing is fully
assembled and the rear covers for the installation bays are in place
(electric shock, cooling, fire protection, interference suppression).
● Install only system extensions that satisfy the requirements and rules
governing safety, electromagnetic compatibility, and
telecommunications terminal equipment. If you install other
extensions, you may damage the system or violate these safety
regulations. You can find out which system extensions are suitable
from the customer service center or your sales outlet.
● The components marked with a warning label (e.g. lightning symbol)
may only be opened, removed or exchanged by authorized, qualified
personnel.
● If you cause a defect on the device by installing or exchanging system
extensions, the warranty will be invalidated.
● Only set the resolutions and refresh rates specified in the operating
manual for your monitor. Otherwise, you may damage the monitor. If
you are in any doubt, contact your sales outlet or customer service
center.
Batteries
V CAUTION!
● Incorrect replacement of batteries may result in a risk of explosion.
The batteries may only be replaced with identical batteries or with a
type recommended by the manufacturer (see the technical manual for
the system board).
● Replace the lithium-battery on the system board in accordance with
the instructions in the technical manual for the system board.
To Next Page
Loading...
Need help?
General