Fujitsu PRIMERGY TX200 S7 - Page 13

System configurator and order-information guide
PRIMERGY TX200 S7 Status 2014-01-30
Memory Configuration PRIMERGY TX200 S7
Each CPU offers 6 Slots for DDR3 Memory Modules organised in 2 Banks and 3 Channels.
If you need more than 6 Slots you have to configure the 2nd CPU.
Depending on the amount of memory configured you can decide between 4 basic modes of operation (see explanation below).
There are 2 different kinds of DDR3 Memory Modules available: UDIMM and RDIMM
UDIMM / RDIMM offer different functionality. Mix of UDIMM / RDIMM is not alloved.
If 1.5V and 1.35V DIMMs are mixed, the DIMMs will run at 1.5V
Mode Configuration Application
SDDC (chipkill) support any no no yes detect multi-bit errors
Independant Channel 1, 2 or 3 Modules per Bank yes yes yes offers max. flexibility, upgradeability, capacity
Mode
use UDIMM modules for lowest cost
Mirrored Channel Mode *)
2 identical Modules / Bank
no no yes offers maximum security
Performance Mode
3 identical Modules / Bank
yes yes yes
offers maximum performance and capacity
Rank Sparing Mode *)
min. 2 Ranks / Channel no no yes balances security and capacity
*) For the delivery ex works the system will be prepared with dedicated BIOS setting.
Capacity Configuration UDIMM RDIMM Notes
Min. Memory per CPU
1 Module / CPU
1x2GB 1x4GB
with one CPU
Max. Memory per CPU 4/6 Modules / CPU 6x4GB
6x16GB
with one CPU
Max. Memory per System
8/12 Modules / System
48GB 96GB if second CPU is configured
Memory-Speed:
Max. DDR3 memory speed depends on the memory configuration on one memory channel and the speed of the CPU
The memory channel with the lowest speed defines the speed of all CPU channels in the system
Voltage setting (BIOS)
DPC DPC DPC DPC DPC DPC DPC DPC DPC
CPU with 1600MHz DDR3 Bus
CPU with 1333MHz DDR3 Bus
CPU with 1066MHz DDR3 Bus
1R - Single Rank
2R - Dual Rank
1DPC = 1 DIMM per Channel
2DPC = 2 DIMM per Channel
Configuration hints:
- The memory sockets on the systemboard offer a color coding:
Bank I black sockets
Bank II blue sockets
- A so called Bank consits of 1 memory module on every Channel available on one CPU (examples see below)
Bank I on CPU 1/2 up to 3 memory modules connected to Channel A - F on the 1st/2nd CPU
Bank II on CPU 1/2 up to 3 memory modules connected to Channel A - F on the 1st/2nd CPU
- See below and next page for a detailed descriptions of the memory configuration supported.
1.5V [default]
1.35V
1.5V [default]
1.35V
UDIMM
RDIMM
RDIMM
Mem. Speed provided
by CPU
UDIMM 1600MHz
RDIMM 1600MHz
Real maximum memory-bus speed depending on CPU type,
memory configuration (DPC) and voltage setting (BIOS)
2
x8
x8
x4
1066
1066
1
2
1
2
1
2
3
-
1333
1333
1333
1
1333
1333
-
1333
1333
1600
1600
1333
1333
1333
1066
1066
1066
1066
1066
1066
1066
1066
-
1066
1066
Fujitsu PRIMERGY Server 13 of 28