Need help?Do you have a question about the Fujitsu PRIMERGY RX100 S7 and is the answer not in the manual?
General| Number of Processors | 1 |
|---|---|
| Memory Slots | 4 |
| Maximum Memory | 32 GB |
| Form Factor | Rack |
| Memory Type | DDR3 |
| Storage | SATA, SAS, SSD |
| Drive Bays | 4 x 3.5" or 8 x 2.5" |
| RAID Support | Optional RAID controller cards |
| Network | Gigabit Ethernet |
| Network Controller | Intel I350 |
| Power Supply | Redundant or Non-redundant |
| Operating System Support | Windows Server, Linux, VMware |
Provides technical specifications for system board, processor, memory, interfaces, and controllers.
Crucial safety guidelines for handling, installation, and operation of the server to prevent hazards.
Procedures and safety precautions for mounting and dismounting the server within a rack.
Instructions for connecting the server's power supply unit to the mains power.
Comprehensive guide to server controls, buttons, LEDs, and indicators on the front and rear panels.
Procedures for powering the server on and off, including first-time startup and alternative methods.
Instructions for configuring onboard controllers and installing the operating system.
Diagnoses and resolves issues where the server's power-on indicator does not light up.
Addresses the problem of the server unexpectedly shutting down, possibly due to detected errors.
Addresses errors indicating drives are not recognized during system startup, often related to RAID controller configuration.
To Next Page
