13
Precautions
■Liability Note
READ ALL OF THIS DOCUMENT, GETTING STARTED, AND OPERATOR'S
GUIDE CAREFULLY BEFORE USING THIS SCANNER. IF THIS SCANNER IS
NOT USED CORRECTLY, UNEXPECTED INJURY MAY BE CAUSED TO
USERS OR BYSTANDERS.
Also, keep this document in a safe place so that it can be easily referred to
during use of this scanner. While all efforts have been made to ensure the
accuracy of all information in this document, PFU assumes no liability to any
party for any damage caused by errors or omissions or by statements of any
kind in this document, its updates or supplements, whether such errors are
omissions or statements resulting from negligence, accidents, or any other
cause. PFU further assumes no liability arising from the application or use of any
scanner or system described herein; nor any liability for incidental or
consequential damages arising from the use of this document. PFU disclaims all
warranties regarding the information contained herein, whether expressed,
implied, or statutory.
Install the ScanSnap away from strong magnetic fields and other sources
of electronic noise. Protect the ScanSnap against any static electricity and
choose a static-free place to install the ScanSnap. Static electricity can
cause the ScanSnap to malfunction.
If there is an electrical storm, disconnect the USB cable from the
ScanSnap and computer. Not doing so may destroy the ScanSnap, which
may damage your properties.
Do not use the ScanSnap immediately after moving it from a cold place into
a warm room.
Condensation may occur, which may lead to scanning errors. Let the
ScanSnap dry for one or two hours before you use it.
When handling documents or an optional carrier sheet, be careful not to
cut your fingers with them.
Do not use a damaged Carrier Sheet because it may damage or cause the
scanner to malfunction.
When carrying the ScanSnap outside while it is raining or snowing, pay
special attention so that the ScanSnap does not get wet.
If the ScanSnap gets wet, wipe it or wait until it dries.
LED light source of this product is not exposed in normal use, and the
intensity of LED light emission does not pose any risk of eye damage. Do
not disassemble, repair, or customize this product by yourself. Direct
exposure to the LED light source could cause problems with visual acuity.
S1100_GS-SP.book Page 13 Thursday, September 16, 2010 11:45 AM
To Next Page
Loading...
Need help?
General
Weight and Dimensions
